Features and Specifications of Bench-Top Universal Testing
What are the features of Bench-Top Universal Testing?
In
Bench-Top Universal Testing tension and compression testing can be performed in
the Test BayTwo precision rolled ball screws with multiple circuit ball nuts
provide smooth, precise motion under the full operating range. Chrome steel
rods and bearings eliminate lateral surface translation and assure accurate
alignment throughout the full range of travel. Heavy fan-fold protects the lead
screws and linear travel bearings from contamination and damage. The loading
surfaces are ground to flatness and parallel standards. Each surface is
fabricated with a bolt circle that provides a means of attaching the system
cell or universal joints or any assortment of testing fixtures to any of the
four surfaces. A joint and linkage for attaching to tensile wedge grips or
similar fixtures is furnished. A universal tension load cell of the frame
capacity is provided with system calibration through the automatic 24-bit load
cell signal conditioner. A high resolution optical encoder is coupled to the frame rotating components furnishes
displacement measurements for test programs, and also provides the control with
closed loop feedback to assure constant travel rate under all load conditions.
Specifications of Bench-Top
Universal Testing
● MTI-10K Floor Model
● Testing Size: 28 inches wide, 60
inches vertical, 8 inches crosshead surface depth.
● Crosshead Travel: 54 inches
end-to-end.
● All Bench-Top Models Frame
Dimensions: 68 inches high, 34 inches wide, 16 inches deep.
● Testing Region Size: 22.5 inches
wide, 48 inches vertical, 7 inches crosshead surface depth.
● Crosshead Travel: 40 inches
end-to-end.
Some Common Specifications:
● Below the Moving Crosshead, in
Tension or Compression.
● Speeds: 0.01 to 10 inches per minute standard.
● Speed range options of 0.02 to 20,
or 0.1 to 50 inches per minute are available.
● Displacement Resolution: 0.00005
inches at standard test speed range.
● Control: MTI C-DAS Intel Core i5
Pentium for computer control of testing.
● Manual control for test setup.
● Weight: Approximately 600 pounds for
bench-top systems, 1,000 pounds for 10K floor model.
● Utility Requirement: 115 volt,
single phase 15 amp AC circuit for load frame and control system.
For more
information visit our website by clicking the link above
Comments
Post a Comment